Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-548-01 Rev. B
ASK Installation Configuration and Connections
Page 4
ASK A9 Projector Configuration
Verify that the System 8/10 PLUS is already configured for the ASK A9 projector.
The general setup is explained on page 3-4 and the switch settings for the
projector are repeated below.
1. Use a small screwdriver to remove the access cover from the System 8/10 PLUS
front panel. See bottom of page 3-3. The label on the back of the access cover
also has the configuration information.
__________ Before changing anything, remove the AC power cord to the System 8/10 P
LUS
to verify that the main power is OFF; also turn the projector power OFF.
2. Set the switches as follows:
Config Model Rotary Switches Cable SW15 Settings Comm
as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter
ASK A9 1 0 E 9 J2 ↓↓ ↑ ↓ ↑↓ ↓ ↓
¯
↑↓ 26-467-01
_RS5 is for RGB switching
delay. See page 3-4 for
more information on switch
functions.
3. Use a grease pencil (or other rub-off marker) to mark the space on the label next
to “ASK A9”.
4. Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless
this is part of a master/slave system, set #3 and #5 to the up position and the
others down. See illustration to the left.
Use the illustration on the following page to do the next steps.
5. Connect the ASK adapter’s 26-pin male connector to the projector’s “Source 1”
port. Next, connect the Comm Adapter’s 9-pin female connector to the projector’s
“RS-232” port.
6. Connect the CC-50' (or CC-100') cable from the 9-pin male connector of the Comm
Adapter to the 15-pin HD “Projector Control” port located on the rear panel of the
System 8/10 PLUS.
______ Secure the screws on all D connectors.
7. Connect the BNC (RGBS) cables from the System 8/10 PLUS outputs to the ASK
adapter’s 15-pin male “Computer” connector. For composite video, connect the
RCA connector from the System 8/10 Plus to the composite video “C” connector
of the ASK adapter. For S-video, connect the DIN connector from the System 8/
10 Plus to the S-video “S” connector of the ASK adapter.
Configured For:
RS-232
345678 9101
2
SW15 DIP Switch
ON
RS5 RS2
RS2
RS1
RS3
RS4
RS1
RS3 RS4
(31 pages)
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals